Credit Card Merchant Services











  Home > SUPER SALE GEAR > Paintball Sale Hoppers & Accessories > Sale Loader Accessories > Halo B/Reloader B/Halo Too Accessories >

  HALO Z Board



 
Our Price: $19.95
Sale Price: $4.95
You save $15.00!


Availability: Usually Ships in 24 to 48 Hours
Product Code: HALOZBOARD
Qty:

Description
 
Z Code has a special jam detection circuit that allows the HALO to determine when an internal jam occurs (out-of-round paint for example). It then initiates a jam clearing sequence which attempts to clear the jam (three times) before changing to a fail safe mode which protects the motor and circuitry for being damaged.
This advanced technology has allowed an increase the rotational force/speed of the HALO without risk of damage. Z Code still includes all of the features of past software updates.
When in fail-safe mode, the HALO will rapidly flash the LED red and green to let the user know of the jam. The user can then clear the jam and turn the HALO off and back on normally. When battery levels are too low, the same flashing will occur to alert the user.
Mfg. Release Date: August 15, 2003. If your HALO was manufactured before August 15, 2003 it does NOT have the most up to date Z code.
How to check if your HALO has Z code: While your HALO is running without paint in it, reach down with your fingers and stop the drive cone from spinning (you need to press down on it fairly hard to FULLY stall it so that it does not move at all). If you hold it down and the motor pulses three times and then the LED starts blinking red and green, you have Z code. If the HALO just keeps "humming" and does not stall out within 5 seconds, you do not have Z code.

Average Review: 3 of 5 | Total Reviews: 1 Write a review.


  3 of 3 people found the following review helpful:
 
BEWARE!!! READ THIS BEFORE YOU BUY!!! February 4, 2009
Reviewer: Nathan  Bohm from Austin, TX United States  
Most newer Halos already have the board with z-codes in it. If you are not sure if your halo is new enough turn it on, then stick your finger in the mouth and keep the feed cone from spinning. It should pulse three times and then stop, and the little LED light with start rapidly alternating between red and green. If that happens then you have Z-codes. If it didn't happen get a V35 board, or something with modes and a higher feed rate.

Was this review helpful to you?


Browse for more products in the same category as this item:

SUPER SALE GEAR > Paintball Sale Hoppers & Accessories > Sale Loader Accessories > Halo B/Reloader B/Halo Too Accessories
Hoppers & Accessories > Loader Parts & Accs. > Halo > Halo Internal Parts

  Warehouse Tour

Free Shipping on orders over $100

Paintball Sale

Price Matching

Contact Us

Retail Showroom

Ninja Tanks

Empire Prophecy

Ape Boards

Exalt Pod Bin

Dye Paint

XLT