|
Quick Links
.
|
| |
1 of 1 people found the following review helpful: |
| |
 |
 |
 |
|
Holds tight |
February 10, 2009 |
| Reviewer:
Matt J.
from Dover, DE United States
|
|
I got this feed neck for my Electra to replace the crappy plastic necks I would break every single time I played. Installation is easy and it looks nice also, probably lowered my hopper down a good inch too. This thing holds tight, once i have it clamped onto my hopper the thing wont budge at all. I currently use a Reloader B which was a tight fit but i didnt have to sand it down to fit it in though; it fit my Viewloader Revy with no problems also. The screws will back themselves out so make sure you tighten them every few games, but i bet Loctite would fix this. Also, this is one of the cheapest feed necks out there.
Was this review helpful to you? 
|
|
 |
|
 |
|
| |
0 of 0 people found the following review helpful: |
| |
|
|
|
|
a must |
February 2, 2009 |
| Reviewer:
gonzalo zaragoza
from yuma, AZ United States
|
|
How many plastic feed necks have you bought and broken? If its more than three then you probably could have bought your self one of these feed necks by now and never had to worry about it again. These necks look, and work great and it makes your hopper sit lower.
It's a no brainer, best upgrade for the buck in my opinion.
Was this review helpful to you?
|
|
|
|
|
|
|
|
