Financing available on all purchases!Prequalify Now >

  Home > General Marker Acc. > O-Rings > Buna O-Ring Kits >

ANS Complete Colored O-Ring Kit 3x Rebuild (Bag) - Bob Long Gen 6 Timmy
ANS Complete Colored O-Ring Kit 3x Rebuild (Bag) - Bob Long Gen 6 Timmy

Our Price: $12.00

Availability: Usually Ships in 24 to 48 Hours


Your marker can fire thousands of rounds every week, puts up with the beating of countless rainy Sundays, and withstands a number of slides through the dirt and mud. Through all of this, you still expect your marker to perform week in and week out. A small bit of maintenance is key to ensuring that your marker functions and performs at its best. One major aspect of marker maintenance is replacing your o-rings. The o-rings in your marker wear down over time by withstanding thousands of cycles along with coming in contact with dirt/debris. Our kits provide an easy and inexpensive way to keep your marker in top shape by swapping out your o-rings.
  • O-rings are color coded by size, eliminating the headache of matching up sizes. An included color/size chart helps with your first time rebuilding your marker. After that, just replace o-rings by color when it comes time to rebuild again.
  • All of the o-rings you need to perform a standard rebuild of your marker three times (other quantities available).
  • Contains o-rings for your markers firing assembly, high pressure regulator, LPR (if applicable), etc (unless otherwise noted). Don't be fooled by other kits that only offer a fraction of the o-rings needed to rebuild your marker.
  • 004 - ASA Plunger
  • 006 - Poppet Shaft
  • 006 - Ram (Front)
  • 008 - Leverlock Adjuster Bolt
  • 011 - Ram (Rear)
  • 011 - Bellville Spring Stack Retainer
  • 011 - Reg Center to Mainbody Front
  • 011 - ASA Knob
  • 012 - LPR Piston
  • 014 (x3) - LPR Housing
  • 014 - Grip Frame to Mainbody Front
  • 015 (x3) - Outside of Bolt
  • 016 - 360 Inline Reg Piston
  • 018 - Inline Reg Center to Reg Base
  • 2x1mm (x2) - Mainbody Rear to Manifold
  • 4x1mm - Grip Frame to Manifold
  • 4.5x1mm - ASA to Grip Frame
  • 5x1mm (x2) - Manifold to Mainbody Front
  • 8x1mm - Manifold to Mainbody Rear
  • 13x1mm - Mainbody Rear to Manifold
  • 15x1mm - Back Block Cap to Mainbody Rear
  • 18x1mm - Mainbody Front to Mainbody Rear
  • 20x1.5mm - Mainbody Front to Inline Reg Center
  • *Kit Contains 1x Rebuild for Metric O-Rings

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

General Marker Acc. > O-Rings > Buna O-Ring Kits
Gun Upgrades & Acc. > Bob Long Paintball Gun Upgrades > Spare Parts
Paintball Manufacturers > ANS Paintball Simi Valley
General Marker Acc. > O-Rings
General Marker Acc.
Gun Upgrades & Acc.
Gun Upgrades & Acc. > Bob Long Paintball Gun Upgrades
(Your shopping cart is empty)