Home > General Marker Acc. > O-Rings > Buna O-Ring Kits >

ANS Complete Colored O-Ring Kit 3x Rebuild (Bag) - Bob Long Victory
ANS Complete Colored O-Ring Kit 3x Rebuild (Bag) - Bob Long Victory

Our Price: $12.00

Availability: Usually Ships in 24 to 48 Hours


Your marker can fire thousands of rounds every week, puts up with the beating of countless rainy Sundays, and withstands a number of slides through the dirt and mud. Through all of this, you still expect your marker to perform week in and week out. A small bit of maintenance is key to ensuring that your marker functions and performs at its best. One major aspect of marker maintenance is replacing your o-rings. The o-rings in your marker wear down over time by withstanding thousands of cycles along with coming in contact with dirt/debris. Our kits provide an easy and inexpensive way to keep your marker in top shape by swapping out your o-rings.
  • O-rings are color coded by size, eliminating the headache of matching up sizes. An included color/size chart helps with your first time rebuilding your marker. After that, just replace o-rings by color when it comes time to rebuild again.
  • All of the o-rings you need to perform a standard rebuild of your marker three times (other quantities available).
  • Contains o-rings for your markers firing assembly, high pressure regulator, LPR (if applicable), etc (unless otherwise noted). Don't be fooled by other kits that only offer a fraction of the o-rings needed to rebuild your marker.
  • 021 (x2) - Volume Chamber (Outside, Front)
  • 020 - Volume Chamber (Inside, Rear)
  • 018 (x2) - HPR (Above Mounting Point)
  • 015 - Pillow Bolt
  • 014 - Volume Chamber (Inside, Front)
  • 012 - LPR Piston (Outside)
  • 011 - Quick Release Ram Shaft (Outside)
  • 010 - Poppet Shaft (Outside, Rear)
  • 008 - Poppet Shaft (Inside, Rear)
  • 006 (x4) - Ram Housing (Outside, Front)
  • 14x1mm - Back Block to Ram Housing
  • 12x1mm - Blast Guide (Rear, Outside)
  • 7.5mmx1mm - Poppet Shaft (Rear,Outside)
  • 6.5x1mm - LPR Housing to Mainbody Seal
  • 4x1mm - Grip Frame to Mainbody Seal

Average Review: Average Review: 1 of 5 1 of 5 Total Reviews: 1 Write a review.

  0 of 0 people found the following review helpful:
1 of 5 Incomplete kit October 26, 2016
Reviewer: Anonymous Person  
Does not include the 3- 1x3mm solenoid orings... BOOO ANS!!!

Was this review helpful to you?

Browse for more products in the same category as this item:

General Marker Acc. > O-Rings > Buna O-Ring Kits
Gun Upgrades & Acc. > Bob Long Paintball Gun Upgrades > Spare Parts
Paintball Manufacturers > ANS Paintball Simi Valley
General Marker Acc. > O-Rings
General Marker Acc.
Gun Upgrades & Acc.
Gun Upgrades & Acc. > Bob Long Paintball Gun Upgrades
(Your shopping cart is empty)